When I did the first short, I knew I was going to need a rig to keep the camera steady. It seemed natural to create one out of LEGO that could, if need be, actually attach to the LEGO floor for some shots. Though the rig went through several redesigns in the four years I created it, it's more or less the same basic design:
Nothing fancy here. The key part to the rig is the Technic Engine Cylinder, and the reason it is key is the hole in the middle where a Technic piston would normally go. In this case, it proved the perfect size for the screw I found that matched the threads in the tripod mount at the bottom of the camera. The Technic Engine Cylinder on the other side simply serves to balance the rig out. Matched with some pins and blocks, the rig worked perfectly.
It was a fine build, but it didn't solve problems I needed with higher angle shots. Fortunately, Mrs. Mosley purchased a new digital camera several years ago and it came with a mini tripod, which I will be borrowing for the project.
There is one more piece of equipment to show (and one of which I am quite proud of), but I am going to save that for the post on the first shot two weeks from now. Until then...
In Two Weeks: The Storyboard
0 comments:
Post a Comment